Display-devices Motorized Rotating Ceiling Mounts Manual do Utilizador Página 1

Consulte online ou descarregue Manual do Utilizador para Projetores Display-devices Motorized Rotating Ceiling Mounts. Display Devices Motorized Rotating Ceiling Mounts User Manual Manual do Utilizador

  • Descarregar
  • Adicionar aos meus manuais
  • Imprimir
  • Página
    / 2
  • Índice
  • MARCADORES
  • Avaliado. / 5. Com base em avaliações de clientes
Vista de página 0
8/7/07 1
MRCM Installation Instructions
Motorized Rotating Ceiling Mount
Positional Feedback Model 8/7/07
Ensure the ceiling structure is capable of holding at least four times the combined weight of
the mount and projector. This is a minimum requirement. Follow any local or state codes that
apply to your specific area.
1. Mount chassis to structural attachment points (i.e., Unistrut
®
, threaded rod). Use
hardware no smaller than ½” (M12). Be sure to use flat and locking washers. We
recommend the following hardware order.
2. Thread lock ring onto each end of the pipe then thread the pipe into the coupling in
the unit. Tighten by hand, and then tighten the lock ring using a flat head
screwdriver and hammer. Thread the projector mount onto the pipe – tighten lock
ring by hand only.
3. Be sure the pipe is level – adjust the mounting hardware as required.
4. Attach handheld remote control cable (5 pin Phoenix style) to the connector in the
junction box. If a control system is used (AMX, Crestron, etc.), the remote can be
disconnected and replaced with control system at the end of installation. Clockwise
= black, Pin1; Counterclockwise = red, Pin 2; Stop = green, Pin 3; and Ground (+5v)
= white, Pin 4.
5. Be sure the electrical circuit is not live. Remove the electrical junction box cover and
knockout slug where desired. Connect the AC power leads: Ground = green, Neutral
= white, Hot = black using the enclosed wire nuts. Replace cover plate and restore
power to the circuit.
Note: the MRCM can be “roughed” in without the projector in place if desired. The
MRCM does not have any hard stop points – do not let it rotate continuously.
Vista de página 0
1 2

Resumo do Conteúdo

Página 1 - 8/7/07 1

8/7/07 1 MRCM Installation Instructions Motorized Rotating Ceiling Mount Positional Feedback Model 8/7/07 Ensure the ceiling structure is capab

Página 2 - 8/7/07 2

8/7/07 2 Programming Screen Positions: 6. To enter programming mode: Press and hold the Stop Button until the LED near the remote plug flash

Comentários a estes Manuais

Sem comentários